How To Recondition Deep Cycle Batteries At Home

deep cycle battery reconditioning

Therefore, a good battery reconditioning process will also fix it. There is s a tipping point, then, beyond which, battery reconditioning methods like desulfation will not work. The lead sulfate that has hardened and crystallized, which can’t be removed by charging, can be removed by another process, called desulfation. This is the most important aspect of battery reconditioning. Sulfation happens because of the way car batteries work, it’s the natural chemical process. The charge-discharge cycles and the chemicals involved produce lead sulfate on the battery plates.

A topic with a thousand names that all mean the same thing, really. Refurbishing and caring for your deep-cycle battery (the type used in marine vehicles his response and RVs) keeps it working longer. The most important things are keeping the battery charged and its electrolytes at their highest recommended level.

deep cycle battery reconditioning

Yes, it is possible to revive a completely dead deep-cycle battery. However, the process is more complicated and time-consuming. You will need to use a desulfator to remove the sulfation buildup from the battery plates. Then, you will need to charge the battery slowly using a low-amperage charger. This process can take several days or even weeks, depending on the battery’s condition.

The positive plate has as a lead dioxide (PbO2) coating. The Lead Dioxide is its active material, which means it can react chemically with the battery acid. Each cell provides 2.13V and when fully charged the sell whole battery has a voltage of 12.72V. Sulfation causes batteries to die much faster than they should. Fixing and rejuvenating batteries, particularly sulfated batteries (by far the most common problem).

And it has high quality charging and reconditioning modes. By the way, if you’re stuck, here’s how to choose between the NOCO and CTEK 5 Amp chargers. The CTEK MXS 5.0 is the best battery charger for those who have a smaller to mid-sized car. It provides the full 8-step charging mode, with 5 Amp charging. Applying a very high voltage to the battery plates would be an effective way to remove the sulfate crystals from the battery plates.

Sulfation is the main reason why deep cycle batteries fail. This is nothing but the formation of sulfate crystals on the battery plates. If the battery is not charged appropriately, then it can cause sulfation. Once a battery is affected by sulfation, it will impact the charging and discharging of the battery and reduce the battery performance.

That means those batteries which have too much of this stuff called lead sulfate on their plates. Lead sulfate buildup is the cause of death for almost all lead-acid batteries. Clean any corrosion off of the battery using a official statement mix of warm water and baking soda. Clean the battery terminals and the inside of the clamps with a post and clamp cleaner. When you fill the cells with water, you can expect that it will immediately make your battery work.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top